ANALOG WATERING TIMER

This analogue water timer or programmer from Wassertech lets you automate watering in a simple and efficient manner.

How to install the programmer/timer:

1. Unscrew and remove the lid. Slide out the battery compartment and insert two new AAA batteries. Then screw the lid back on.

2. Turn the timer wheel to the OFF position. You should hear the motor noise for about 30 seconds. If you can't hear it, recheck your battery placement.

3. Position the programmer in a stable place by loosening the locking collar on the top ring until the faucet collar is loose. Then open the water supply faucet.

How to program the programmer/timer:

1. Rotate the dial to set the watering time in hours and minutes. The programmer won't start watering immediately; it will begin after the designated time has elapsed.

Example: If we want to program watering for 10 AM and 10 PM, each for 20 minutes, set the frequency wheel to 12 hours and the watering time to 20 minutes. However, if you prefer to schedule just one watering per day, simply set the frequency wheel to 24 hours.

2. Adjust the device's date and time. You can use the “ON/OFF" function without interfering with your settings. Turning the timing wheel to ON then OFF for 5 seconds will reset the programmer for another watering session.

3. Once set, close the waterproof lid tightly and ensure it's securely fastened.